Flush Mount
The Flush Mount is a black, recessed pin light that can be installed to highlight and accentuate a range of architectural and joinery features.
SPECIFICATIONS
Power: 1W Built-in-LED
Lumen Output: 100lm
Colour Temperature: 3000K
Cut Out: Ø12.3mm (31/64 drill bit).
Depth: 24mm, allow 10mm more.
Adjustability: Fixed
CRI: 90
IP Rated: 68
Wiring Info: 240V to driver, low voltage to fitting. If more than one fitting, wire in parallel.
Input: DC 12V
Beam Angle: 120°
Dimming: DALI, requires more than one fitting.
Warranty: 3 years.
FINISH OPTIONS
Glossy Black
PRODUCT GALLERY
DOWNLOADS
Photometric IES Files
Electricians must use silicon-based heat shrink to secure the back of the fitting, ensuring there is no water leakage and allowing for proper drainage during careful installation to prevent water damage.
Failure to adhere to these guidelines will result in voiding the warranty.
-
• 36W/12V Driver (Dimmable) - Remote Driver
• 75W/12V Driver (Dimmable) - Remote Driver
-
• 36W/12V Driver (Dimmable) - Remote Driver
• 75W/12V Driver (Dimmable) - Remote Driver
• 150W/12V Driver (Dimmable) - Remote Driver
• 240W/12V Driver (Dimmable) - Remote Driver
WIRING INFORMATION
Constant voltage 12V drivers must be wired in parallel. See the below diagram on how to wire in parallel.
DRIVER OPTIONS
